3d modeler needed for iPhone 5 car dock

Discussion in '3D Design Requests' started by dcantato, Oct 13, 2012.

  1. dcantato
    dcantato New Member
    It can be using available templates or anything along those lines since this will be likely a one print design. I can send you the stl files I've already gathered up if needed.

    Basically it will be a simple holder/stripped down case with a area to insert a lightning cable.

    I would be thinking to base the cable holder off this:
    http://www.thingiverse.com/thing:31429

    And combine it with a sleeve like this:
    http://www.thingiverse.com/thing:30510

    And have a piece sticking out of the sleeve at a slightly tilted angle so that I could mount it where needed. Please send me PM's with estimates. Thanks for your time.
     
  2. WarrenSainvil4
    WarrenSainvil4 New Member
    I think I can help just Pm me with the measurements