1st set of product test prints

Discussion in 'My Shapeways Order Arrived' started by Youknowwho4eva, Dec 22, 2009.

  1. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    This is my favorite. Although too small for me to wear I love how it came out.

    http://www.shapeways.com/model/63675/printing_approved_brace let_.html

    Every link is a 1mm thick. It looks so fragile. A larger version is going to come soon as I did have to work some of the links free of each other, and it would only fit a small wrist right now.

    This one probably came out the most as I expected.

    http://www.shapeways.com/model/64352/geared_up.html

    The gears unfortunately don't move. But I haven't got to really try to clean it yet. Other then that fits great, and looks great.

    This one you can't see the detail in the pic, and very little of it came through.

    http://www.shapeways.com/model/49234/double_headed_coin.html

    But if you look at the very low lettering areas, you can just make it out (not in the picture, on the actual) Most of the ribs on the outside of the coin didn't survive which surprised me...

    This one I took off because it was too small also but came out wonderfully so I figured I'd share that.

    IMG_0337.jpg

    Last but not least, this week should be getting my mayan pendent, and my Flicka 2.0/2,1 test in stainless!
     
  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    2nd set in. Happy with my Flicka 2.1. Mayan pendent didn't come out well in stainless :'(. I'll enlarge it to see if I can't get better clarity out of it.
    photo(5).jpg photo(4).jpg photo(3).jpg photo(2).jpg photo.jpg