zanenobbs

Designer, Product designer, Maker
President International Resin Modellers Association, Professor of American Government

0
Followers
0
Following
zanenobbs's
zanenobbs commented on Nm YsteC Ge 4/4 (Crocodile) (1:160) by yvesg
April 14, 2018
Nm YsteC Ge 4/4 (Crocodile) (1:160)
zanenobbs Greetings, I ordered the Nm YsteC Ge 4/4 (Crocodile) in 1/87 which is narrow gauge HOm, and it almost fit over the Bemo 1258 000 chassis, but was just a bit too small on the inside. There are two ways to resolve it for HOm: 1. would be to match the Bemo dimensions internally with thinner walls. The Bemo chassis is 27 mm wide and 125 mm long with curved ends, and 7 mm deep. 2. A resin chassis could be made to accommodate the Bemo bogies and motor. If it helps I can send a Bemo chassis to modify a 3D chassis from to complete the project. All other aspects of the Bemo chassis are the same for the Nm YsteC Ge 4/4 (Crocodile) and the other Ge 4/4s. I can send some photos to demonstrate how it could be done. Please let me know how much it would cost. Thank you.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.