FREE SHIPPING on orders over $25! Sale ends in days. Details

wendell camp

wendellcamp


0
Followers
1
Following
wendellcamp's
wendellcamp commented on N Coal Rotary Dumper FUD Parts by baldylox
August 7, 2016
N Coal Rotary Dumper FUD Parts
wendellcamp from the image you show it looks like you have to cut a slot in the base fore belt to thorough to the pulley The other problem is how to index it when in come back up from dumping so track lines up That may be be expecting a lot Wendell
wendellcamp baldylox Is the wood chip end big then the coal dumper
wendellcamp shapeways did't allow bigger pictures to be I can send you a bigger one the base where the rollers go needs to be wjder or roller need to be narrowermine was not polish I used the tube size 225/226 I have the you suggested set for 400X1 it seems slow engought I hope you don't think I was complaining I new this was a BETA project Also as it is set up I don't know how to run the belt down to the motor?? Thanks Wendell
wendellcamp I built the dumper if you have coal porters they will not fit in to the dumper. The older coal cars will. I have the motor for this but haven't got the belt yet I am not sure this will operate as the rollers do not move! I had to dill out the ident where the tubes glue in as they were not deep enought
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.