Just a few days left to Make Your Holiday!
Check order deadlines

Quentin Bowden


3D modeler, Product designer, Maker

Check out this cool product! - http://shpws.me/Mrhw Backbone - Lightning Cable Protector (V2.0)
Tunuva commented on Backbone - Lightning Cable Protector by Tunuva
December 15, 2015
Backbone - Lightning Cable Protector
Tunuva @arminafshary It is something that we can certainly look into. Why don't you message us privately to discuss more.
Tunuva @Vss123 Yes it is! Please feel free to send me a PM.
Backbone™ Cable Protector [30-Pin Connector]
Tunuva @BenTate That is not the case. We have been using Backbones on our cables for almost 18 months and have never had a cable fail. The chargers break because the weakest point of the cable is allowed to flex during use. This causes the wires inside the cable to disconnect from the circuit and stop working. Backbone strengthens your cables by allowing minimal movement at the failure point.
Tunuva @BenTate there is not much flex to the part. I'd probably say it'll move about 0.15" in all directions before breaking.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.