teron


0
Followers
0
Following
teron's
Heavy Tread Combiner Knee Joint W PCC Port
teron Hey, i bought your item, received it, watched your video tutorial as well for assembling it..have some feedback for you. 1. Aside from the usual cleanup required, I would suggest M3 x 8mm to 10mm screws. 2. A pilot hole of about 2mm for the screws (combiner port) should be designed, if not it should be drilled before fastening the screws 3. The spots for cleaning up can be reduced, if you could reduce the width of the clip by 0.5mm(not sure if thats possible, but i had to shave off quite abit before i can get the combiner port to fit properly. 4. The round post which the combiner port swivels on is super tight, until i could not fit the encasing pieces for the combiner port.
Triple Changing Sword For Gen Springer
teron @WingbladeZero oh yes i saw it..the images didnt load on the mobile browser..
teron Hi there..do you have any assemply instructions for this?
teron commented on b_hand by 3dprintron
May 16, 2015
b_hand
teron can the fingers and thumbs be individually poseable?
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.