Antonio Sum


sumantonio commented on Evolv DNA200 Case with Buttons by slutlab
July 25, 2015
Evolv DNA200 Case with Buttons
sumantonio @XenonRam If only! I'm in Europe those 2-56's were only available at model shops and eBay they were like 15$ for 10! I went metric m2*20mm and all is good!
sumantonio @scoopy79 It's 3D printed ;) here is a PIC of the front section with mounting holes and screen cut out.
sumantonio @windxrunner I'm using m2 x 20mm as I am in Europe, US sizes are just to expensive. I hope everyone's build goes well!
sumantonio Many thanks print came today all good, m1.6 x 5mm are a bit long so 4mm should fit.
sumantonio I am struggling to figure out what the equivalent metric sizes are for case and board screws? - The case screws as 2-56 pan head .75" long stainless steel - The board attachment screws are 0-80 round head .1875" long stainless steel


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.