Eric Oxford

stopmoeric

3D modeler, Animator, Designer, Artist
I'm a professional stop-motion armaturist, puppet fabricator, and animator.

1
Followers
0
Following
stopmoeric's
stopmoeric commented on T-Bar Tool by Tofty
October 19, 2015
T-Bar Tool
stopmoeric Also, if the new design works, I'd try and update some of your photos.
stopmoeric I should of done it a lot sooner, I finally grinded down the corner bit for the bottle cap opener. I removed as much material as I could before it effect the screwdriver tip part. It helps slightly, but still doesn't make for a good opener without risk of breaking the glass. The problem is that where it hits is right at the edge of other side of the bottle rim, so it puts a lot of pressure there. If you look at other bottle openers, you'll see how the fulcrum is more before the edge of the bottle, like 3/4, which helps bend the cap. I think your new design work probably work. Have you ever tested it? If it did, I'd try it out. Though I don't think I'd pay full price for it again.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.