Just a few days left to Make Your Holiday!
Check order deadlines

Daniel Lee

SpragClutch


0
Followers
0
Following
SpragClutch's
BK117 Clutch Cap Tool - Clamp (P/N: CCRT-2)
SpragClutch Found to fit and work on a very limited amount of BK117 series helicopters. Will remain in beta until I can get a broad range of BK117 types of helicopters tested.
SpragClutch I made two of these with hardware from a local hardware store, and printing them on my 3dprinter. One was printed with Taulmans Alloy 910 and the other with Polymakers PC-Plus. Both 100% infill. I have not been able to test the tool, but I think the plastic will be strong enough. Shapeways Strong and Flexible Plastic (Nylon) should work just fine. I will update when I have fully tested this tool.
BK117 Clutch Cap Tool - Pull Handle (P/N: CCRT-1)
SpragClutch Found to fit and work on a very limited amount of BK117 series helicopters. Will remain in beta until I can get a broad range of BK117 types of helicopters tested.
SpragClutch I made two of these with hardware from a local hardware store, and printing them on my 3dprinter. One was printed with Taulmans Alloy 910 and the other with Polymakers PC-Plus. Both 100% infill. I have not been able to test the tool, but I think the plastic will be strong enough. Shapeways Strong and Flexible Plastic (Nylon) should work just fine. I will update when I have fully tested this tool.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.