ricsuth


0
Followers
0
Following
ricsuth's
ricsuth commented on Evolv DNA200 (106x37x26 Battery) by slutlab
December 8, 2015
Evolv DNA200 (106x37x26 Battery)
ricsuth @lalemandrew Sorry, I don't. I have a few shots of the balance connector wired up to the board and the battery (after shortening the leads). Not sure internal shots would show too much - it's a pretty tight fit!
ricsuth Been running this for about a week now. Using the suggested Turnigy 2200mah battery. Went together without issue but using the xt60 connector instead of hard wiring the power so had to trim the battery leads down A LOT. As mentioned in a previous post, screws went in no issue and I've removed and replaced them a few times now without a problem. Great 3D print too but you can tell there's a certain way round the back needs attaching (the 'grain'). The support for the board was a bit of a pain but if you use a small hex key under one of the ground screws on the back edge to pull upwards it slips out okay. Going to place an order for another smaller version shortly and some coloured buttons...
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.