Just a few days left to Make Your Holiday!
Check order deadlines

Paul Jordan

paul_jordan28


0
Followers
0
Following
paul_jordan28's
paul_jordan28 commented on SX350J Panel Print by Podunk_Steam
November 26, 2015
SX350J Panel Print
paul_jordan28 @LunaMods not sure to be honest i haven't bought another yet, ive had my sx350j chip for months now and desperate to get it into a mod but just cant afford it being disabled!
paul_jordan28 @Podunk_Steam yeah sorry seemed a bit abrupt and rude reading it again! the mounting holes are slightly to far apart,meaning you can only screw the chip to one side of the board,they need bringing in towards the center of the panel by1.4mm each side. also raise them up by 1.5mm-2mm, the bottom mounts under the fire button need moving futher down by1.1mm and the top mounts could do with moving up by 1mm there is room with out changing the fire button. sorry about that i hate non constructive criticism i will ask to get it removed asap, apart from that its great
paul_jordan28 @Podunk_Steam This SX350J Panel Print doesn't line up with the sx350j chip as the mounting holes are to wide apart, there is either no recess for the screen or the mounting holes are way to short, for 6th version attempt not great. it will take a lot of work and and arildite to secure the chip, i have photos on request, my phone is bugging out at the moment and cant upload them!
paul_jordan28 added a product to a list
October 23, 2015
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.