Michael Reeves

michaelreeves21


0
Followers
0
Following
michaelreeves21's
Alpinetech A+ Replacement Lid DNA200
michaelreeves21 Also looks like quite a few millimeters could be saved if the balance connector was extended and tucked under the battery?
michaelreeves21 @Dznutz how is the print holding up? Did you seal it? Any extra room left in the box? Is there room to extend the balance connector off the board to make it easier to unplug? Snug with the screws? Could the xt30 fit under the battery at the bottom? Also is there a screen holder? Thanks
michaelreeves21 commented on Evolv DNA200 (106x37x26 Battery) by slutlab
October 6, 2015
Evolv DNA200 (106x37x26 Battery)
michaelreeves21 Was there more picture I'm.missing? Mines in production but would like to see some pics with the battery or chip installed.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.