Maggie Lampach


The Swirl - Fidget Spinner - For Your Idle Hands
maggielampach Hi Sean. I replied on your forum post but I'll post the same here too. The spinners are just a tiny bit too big. If I put in the bearings while they spinners were on a table and then lifted them up, all the bearings would stay on the table. I'm sure a bit of glue as you suggested will do the trick.
maggielampach Nevermind. I guess I didn't read far enough into the "about this product" to see "or add a dab of glue". Guess I have to buy some glue tomorrow. Thanks.
maggielampach Worst case scenario you didn't figure... they're too big! I purchased two of these and a bunch of the bearings on eBay suggested in your "about this product". The bearings are either too small or the spinner holes are too big. The bearings fut right through and fall out. Any ideas how to mod to make the bearings fit and stay in? Thanks.
maggielampach favorited Hoodwink Bronze by Brian_Richardson
September 9, 2016
maggielampach favorited Tardigrade Bottle Opener by EricHo
September 9, 2016


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.