Just a few days left to Make Your Holiday!
Check order deadlines

Lazerlord

Maker
I'm not very good at modeling, but if you're looking for my designs, go to thingiverse.

0
Followers
1
Following
Lazerlord's
Lazerlord commented on Owl Bear by mz4250
January 26, 2017
Owl Bear
Lazerlord I printed one of these out for my friend! 0.05mm layer height, z-hop enabled, cura slicer, lots of supports. Pictures here: https://twitter.com/Lazerlord10/status/824421391822974976
Lazerlord commented on Tiefling Rogue by mz4250
January 22, 2017
Tiefling Rogue
Lazerlord This model was perfect for my character in pathfinder! (+18 to sneak, lol) Changed out the head (Lizard folk) and tried it out with surprisingly good results on my FT-5. I didn't even use any brim, just support! https://www.reddit.com/r/3Dprinting/comments/5pf3am/today_i_printed_a_representation_of_my_character/
Lazerlord commented on Dragonborn Sorceror by mz4250
January 22, 2017
Dragonborn Sorceror
Lazerlord Just an interesting observation: I can't seem to find this model on your actual profile. If I do a google search for it I can find it, but I can't see it when looking through your creation section here on shapeways. Also, I used its head in this print, take a look: https://www.reddit.com/r/3Dprinting/comments/5pf3am/today_i_printed_a_representation_of_my_character/
Lazerlord commented on Red Dragon (Updated) by mz4250
January 18, 2017
Red Dragon (Updated)
Lazerlord @moocowmunk_dt they were printed with the thumb facing down with the wing tips facing up. make your hand flat and make your thumb touch a table and you'll see what I mean. I used 45 degree supports and it worked well enough, but the layer adhesion between the wing and thumb sometimes breaks, but super glue fixes it rather well.
Lazerlord @mz4250 Just did! I posted this link http://imgur.com/gallery/QNbUC
Lazerlord @mz4250 Gotta say, this is my favorite 3d print so far. If my printer could print this, I think it's pretty well tuned right now. It's only been a week since I got it, and I gotta say, I'm very pleased.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.