kerberos


1
Followers
8
Following
kerberos's
kerberos added a product to a list
March 8, 2017
kerberos favorited Full Animatronic Skull by InnerbreedFX
March 8, 2017
kerberos favorited Deago Greeble set 1 by Sonic_Sun
February 16, 2017
kerberos added a product to a list
February 16, 2017
kerberos added a product to a list
February 16, 2017
kerberos added products to a list
February 15, 2017
kerberos added a product to a list
February 14, 2017
kerberos commented on YT1300 DEAGO CABIN DOOR FRAME STOCK by TonyRR
February 3, 2017
YT1300 DEAGO CABIN DOOR FRAME STOCK
kerberos Hi Tony, do you have a door frame that fits your back wall? I have the ParaGrafix back wall and want to add your frames for thickness. Already have your floor, seats and front parts and hallway behind. Is this one just shorter, won't reach the bottom of the floor?
kerberos commented on YT1300 DEAGO COCKPIT SEPARATE PARTS FLOOR by TonyRR
January 31, 2017
YT1300 DEAGO COCKPIT SEPARATE PARTS FLOOR
kerberos @TonyRR "So if the Paragrafix upper wall is not interfering with the slope part of the cone, you can use it. " Checked my ParaGrafix parts with this cockpit parts set, because of the extended length of the cabin walls there's about an 8 or 9 mm gap between the ParaGrafix cabin walls and the overhead controls piece. May be nice to have a separate cabin wall piece with just the front, jerry cans ovrhead section. I haven't assembled mine yet for exact gap size, but the upper cabin wall depth of the Paragrafix is 24mm.
kerberos commented on ESB/TFA Grip Guide (Version B) by graflexguide
January 18, 2017
ESB/TFA Grip Guide (Version B)
kerberos @graflexguide Compared to Roy's original calculations for the number though....
kerberos @graflexguide Someone on the RPF made this graphic from Roy's calculations posted in the TFA Graflex Research Thread. Outside is the TFA Hero saber, Inside is the TFA Maz box saber. I used the Hero dimensions for my hilt.
kerberos Could use a cutout on the bottom for a Kobold clip, I didn't use the rivet guide to drill holes as the the TFA rivets are in a different place than the ESB rivets, it was hard to get the grips lined up with the clip as I lined them up as I was putting the grip guide on, but after I removed the guide they were off by a bit and had to reattach the guide and slide everything over about 3mm, had a bit of clean up then removing the exposed epoxy. Maybe not an exact Kolbold clip hole as I could also see people using it went attaching the clip and not being able to get the guide off with the D-ring in the way.
kerberos commented on YT1300 DEAGO QUAD RADAR EP VII 75 MM by TonyRR
April 19, 2015
YT1300 DEAGO QUAD RADAR EP VII 75 MM
kerberos Was that really the filming model at Anaheim? Looked like they just had a Fine Molds kit on display with the new dish added. Both trailers look like they are using the 5 foot studio model. I assume digitally scanned, or bought/borrowed one built from one of the guys on RPF like they did for R2
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.