John Long

John_Dillinga


0
Followers
2
Following
John_Dillinga's
John_Dillinga added a product to a list
January 10, 2018
John_Dillinga added products to a list
December 27, 2017
John_Dillinga added a product to a list
December 8, 2017
John_Dillinga added products to a list
November 15, 2017
John_Dillinga added products to a list
July 13, 2017
MTMTE Rodimus chest (Part 1 of 2)
John_Dillinga When you get the two chest parts available will the knee parts also be available?. I’m eagerly awaiting this set!.
John_Dillinga added products to a list
July 13, 2017
John_Dillinga added a product to a list
July 12, 2017
John_Dillinga added a product to a list
May 8, 2017
John_Dillinga added products to a list
May 8, 2017
John_Dillinga added a product to a list
November 10, 2016
Scorponok Headmaster Adapter Revision
John_Dillinga And from the front with the head attached.
John_Dillinga There we go.
John_Dillinga @anthony_oster I went back and looked, and actually it's the top layer of the piece itself, so it's not solely the con symbol, the top is actually a slight bit above the shoulder layer so the scorpion head won't sit flush on it, I keep trying to add a pic to show but the page has an error when trying to upload. I'll keep trying.
John_Dillinga @anthony_oster actually after transforming it to Scorpion/tank mode the rotation of the piece actually helps because when left in the normal position, the Scorpion head pieces don't tab closed I think the raised con symbol might be preventing the two parts from tabbing together properly and I didn't want to force it, but other then that the piece is fine. The headmaster can still stand in the cockpit in that mode, and in jet mode if you fold his legs up under him in a knelling posistion he can sit inside with it the piece in the normal position. Now for anyone else the cockpit hatch/door won't close with the figure in it as it wasn't meant for it to do so but for display it's fine.
John_Dillinga I ordered it and after a bit of a pain pulling Cybertron Dark Scorponok apart, since you have to remove the entire right side, it slid on easily and it actually does move slightly (up and down in Botmode for a quasi neck pivot) and it will rotate around in Altmode which I'm not complaining about but just letting you know. For the PE Black Zarak head turn the entire head sideways when inserting it into the clips, it's a lot easier that way.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.