Just a few days left to Make Your Holiday!
Check order deadlines


jlaf2112 commented on Cougar Button S1 by debolestis
October 22, 2016
Cougar Button S1
jlaf2112 @debolestis, I figured out a way to make it work. there is a piece inside where the button goes. it is like two tabs if you break those tabs off there are 2 but it is one piece the button fit in perfectly.. I guess with the thicker wall those pieces made it not fit. but after removing the tabs they fit perfectly.. ;)
jlaf2112 here is a picture of the original (Grey) and the one I bought here (Black)
jlaf2112 @debolestis, I am buying a Micrometer tomorrow so I can get more accurate measurments.. I will measure the inside hole and outside wall to see how thick it is..
jlaf2112 @debolestis, I received the button today. it will infact work on the Pinky Button and MSL Step button they are the esame.. I did have 1 small problem it did not fit quite right.. It looked as the wall on the shaft looked thicker then the original?? the size of the hole seems the same as I measured it but the wall thickness looks thicker then the original?? Did you get the dimensions from the original button??
jlaf2112 @debolestis, Yes I see it is for the Cougar I was just wondering if it was to fit for the Pinky Switch and not the Pickle button.. it does look like the pinky button but we shall see looking forward to getting it to check.. I will let you know foir sure which button it is..
jlaf2112 @debolestis is this the pinky button on the Thrustmaster Cougar stick??


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.