15% Off Multi-Color Polyjet with code "NEWJ750" at checkout

Jessica Kings


JessieK commented on Mimic - Book Case by mz4250
February 27, 2017
Mimic -  Book Case
JessieK @mz4250 Thanks very much!
JessieK I can't seem to find the chest mimic? Is it about or is it not something you've put up yet?
JessieK commented on Half Orc Cleric or Paladin by mz4250
February 21, 2017
Half Orc Cleric or Paladin
JessieK @mz4250 Well now I do feel the fool just saw the option in the software I use...not my finest hour thank you! haha
JessieK @mz4250Ah gotcha thank you! I've found with some of the models on here, printing the model as is causes a lot of the PLA to drip and become warped this tends to happen around extended arms, I assume this is my printers issue then not something I am doing wrong in prep as I am printing the models you give as they come. Thank you very much for your time, I will be upgrading my printer to take advantage of your amazing models
JessieK @mz4250 Ah so you do take them apart from before printing? That's good to know. I read most people doing that but didn't know if it was common place. Again sorry to be a pain but do you take the arms off and then print the full body? Or is it more than that? Thank you for your recommendations these printers you recommended seem to be in my sort of price range (Below £500 for some of there more simple products)
JessieK Can I ask what 3d printer you use or one you would recommend to a beginner, I love these models and would love to print them, but I've tried a few with my XYZ printing junior and the results have been messy, stringy and sometimes just unusable, I know this isn't the best place to ask but I would love to learn more and resources out there are limited.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.