Focaldesign@debolestis I used the screws that came with the Cougar.
Screws are less the problem I assume; When you compare original with yours, you see yours start higher and not flat on the wider part. Therefor screws, part of the connector etc all shift the same amount.
Focaldesign hi, me again. I was searching for the reason why my stick felt wobbly. Found out I think. See comparison of stock hotas and with your part. The black plastic part of the connector should be equally high as the metal parts that go into the stickbase. Here they are lower and the connector sticks out. Also the screws from the connectorsides then are higher and rest on the stickbase plate.
Focaldesign@debolestis aha ok.
Looks good on mine. Hope it is strong enough to stand the force on a force sensing stick.
Focaldesign@debolestis no need to be sorry. I knew it was in beta. I just wanted to let you know, just in case you would make adjustments if necessary. But needed anymore now as it's only the top part now.
Focaldesign@debolestis On 11/6 I ordered the similar part (then named POV with castle hats). Just to let you know the part that goes underneath the visible circle with castles was about 0,9mm too thick to fit in the Cougar. It fitted but the switch couldn't be pushed in any of the 4 directions anymore. Had to file it down gently until it was moveable.