Logitech G930,G430,G230 (R/Inside) Headphone Brack
fidelisoris Ordered both inside L and R brackets as both of my originals have suffered catastrophic failure. I'm very thankful the community has picked up some of the massive slack that Logitech failed on with the G930 headsets. A few notes on my pieces: - They were not identical, one side had obvious 3D printed "steps" on the outer surface, and it's fairly obvious they were 3D printed pieces. However, they go against your head so it's really not important. - You may need to clean up some of the factory plastic mold posts on the OEM outer brackets to get these to fit properly. I used some surface-snips. - The screws are extremely easy to strip when reinstalling. Remember you are threading into plastic.Even with my precision screw driver, I held onto the screwdriver shaft to tighten and not the handle. - Once installed, you may notice the pivot is slightly tighter. This is a good thing, as it demonstrates the improvements this piece has over the factory ones. Thank you again to the original designer of these pieces. You've further delayed my purchase of a different and better brand of headset for the time being! Now I'm off to perform the transmitter antenna mod!


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.