FREE SHIPPING on orders over $25! Sale ends in days. Details

fbc53c0


0
Followers
1
Following
fbc53c0's
fbc53c0 commented on Shadow by mz4250
January 27, 2017
Shadow
fbc53c0 @mz4250 Thanks for responding! The main issue I have had is the support not pulling off of the lowest finger. I just finished a test with a lower temp PLA(Was using 210-225 rated media, switched to 195-210) and the support removed a lot easier.
fbc53c0 Miguel, I've been trying to print your Shadow figure. It's coming out pretty well, but I've been struggling a bit with the hands/fingers breaking off when I remove the supports. In your photo, it kind of looks like the hands are a bit more solid, is that the case, and do you recall if you did that through overhang support or something like that? I'm using Cura for slicing, if that helps. Also, this series is fantastic!
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.