Just a few days left to Make Your Holiday!
Check order deadlines

James Farinha

farinha_james


0
Followers
1
Following
farinha_james's
farinha_james commented on Beholder (updated) by mz4250
21 days ago
 Beholder (updated)
farinha_james @georgedorn A guy sold me a printer that he 3D-printed and assembled himself. The design is close to his original Dagoma printer (DiscoEasy200). If you want to print minis and have more budget than I, go for something not that cheap. I often need to slice the files from MZ to successfully print them and spend a lot of time after printing and before painting to have a good results.
farinha_james @mz4250 I am printing at 35mm/s most of the time. My problem is when I am jumping from one tentacle to the other, my retraction is not good enough to prevent some plastic to spill from the nozzle during the travel time. This leads to crapy results in good case and print faillure in bad case. (And if I try to retract more wire or faster, I damage the wire etc., I did not find the good balance yet). I have done (and commented with a picture) on your Death Kiss also. I love your work dude, I don't make comments on everything I've done from your gallery, it would take too much time ;) -mostly because this website is a mess when it comes to find one particular model among your 18 pages...
farinha_james @mz4250 I had to print the tentacles separately (because of my printer/settings) but have a nice result, thanks !
farinha_james commented on Orcus by mz4250
26 days ago
Orcus
farinha_james Here it is! Thank you again for the model.
farinha_james I am starting printing one. I hope it will look as good as yours. The painting is nice btw!
farinha_james commented on Beholder - Death Kiss by mz4250
October 24, 2017
Beholder - Death Kiss
farinha_james Thank you again for this model and all the others!
farinha_james commented on Tiefling Staff Wizard by mz4250
July 22, 2017
Tiefling Staff Wizard
farinha_james Any chance for one of you guys to send me a Cura profile for this kind of figurines? I am beginning with 3D printing and it's a bit tricky to print this kind of figs for me... (I know my printer may need different settings from yours but I will have a starting point...). email at masterjf@hotmail.com Thanks!
farinha_james commented on Giant Ape by mz4250
July 7, 2017
Giant Ape
farinha_james Thanks for this one! I like it and am using it for Polymorph! Any plan on doing a T-Rex one day for the same purpose? Love your work anyway, I felt like buying a 3D printer when I've seen your work and what I could print then.
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.