derProtoTyp@TwinsRRUs Sorry to get back so late! March was pretty busy but finally I had some time to play around with the bit holder and try to adapt it. But unfortunately there are just too many measurements I would need the real thing to double check. I´m getting emails from the local equivalent to craigslist if a bosh cordless drill / impact driver shows up and if I find a cheap or broken free one I´ll get it and adapt the bit holder. hope your solutions works for you in the meantime. Way cheaper anyway :)
derProtoTyp Fits an all makitas that look similar to these: the 3d printed part aligns against the two pockets from the screws that connect the two housing halves & a screw in the thread-insert connects it to the housing. It follows the round shape of the handle to give extra support
derProtoTyp hi @TwinsRRUs, unfortunately I don´t own a bosh machine from which I could take the measurements to adapt the bit holder. but if you want you can send me some pictures/sketches of the dimensions of the hole and the feature where this metal hook mounts against (+surrounding housing geometry) and I´ll do my best to adapt the 3d model and upload it here. If I set it to beta you should be able to order it and give me feedback if there are any modifications to make. pictures should ideally be straight on and from front/back and include a ruler/callipers so I´m able to transfer these dimensions into the 3d program. metric would be great but if you don´t have anything handy I should be able to figure out the inch-fractions as well :D post>at
derProtoTyp hi @aafgra, the holder fits any standard 1/4 inch hex-drive bit (6,3mm). slotted, phillips, PZ, torx, hex...