biff2 commented on GoPro Hero 3 Lens Hood - Small by K2theM
August 28, 2015
GoPro Hero 3 Lens Hood - Small
biff2 The small one was the Fusion Imaging print, not yours.
biff2 Will do. Do you have an email address you would rather have me send these to rather than posting it here in the comments section? Either way is fine by me. Thank you!
biff2 @K2theM Feel free to reach out to me directly for a quick video of the fit as this is not an odd camera, and most any of the current GoPros use the same dimension. I had ordered your lens hood, and another smaller one for windy days on the Phantom. The smaller fit very snug. Let me know what I can do to help you out with your design.
biff2 Is it safe to assume that these could vary in size due to the amount of post-print polishing was done on the product? The unit I just received is loose enough on the lens that I can see an air gap between the lens and hood. This hood is not useable on a my GoPro Hero 3+. I would imagine it would take at least one if not two wraps of electrical tape to allow the hood to grasp onto the lens. Did I get an old design?
biff2 added products to a list
August 17, 2015


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.