Angela Bond

angebond007


12
Followers
1
Following
angebond007's
angebond007 commented on DNA200 mixNmatch by viveck
December 31, 2015
DNA200 mixNmatch
angebond007 @Jvape78 and its funny how i described my points with intelligence and backed them up with facts and the best you could do was call me names and wish death upon me. Speaks loads to your knowledge and experience.
angebond007 @Jvape78 did spouting off like that make you feel like u didnt have a micro penis?
angebond007 @Jvape78 First, temp control isn't power hungry, in fact it saves battery life. Say you set your mod @ 75watt or joules & 400degF your mod will fire @ 75watt until it reaches 400deg then will drop the wattage to whatever it needs to in order to keep your coil at 400deg in comparison to wattage mode that would continually fire @ 75watts. Second the Samsung 30q isn't really the best battery to be vaping with, as per the datasheet it has a max discharge of 15A @ Capacity after 250cycles ≥ 1,800mAh (60% of the nominal capacity) 250 cycles is incredibly low for today's standard of recently released batteries. Say you have a evic mini single battery 75watt mod with a 0.3ohm coil @ 67.5watts you'll be at 4.5v and already pulling the 30q's maximum of 15A, so now you max out the mod at 75watts and your well over the safe limit and in risk of venting. Good rule of thumb is give yourself headroom and not to use anything less than a 20A battery but best to use a 30A and keep things safe.
angebond007 favorited DNA200 mixNmatch by viveck
December 4, 2015
angebond007 favorited Circuit Atty Stand by Marici
November 5, 2015
angebond007 favorited Mion DNA200 C-Frame by CGTMods
October 7, 2015
angebond007 commented on SX J Bezel by DavesMODs
September 21, 2015
SX J Bezel
angebond007 Thank you very much for coming up with trip panels for the sx350j that can be used for someone's custom build, ive been looking for something to cover up/replace the oversized holes I cut in the side of my cnc 1590g box. Im also in need of this replacement piece to free up about 2-3mm of space from side to side to allow room for my Nano-Tech lipo, that stupid HUGE inductor on the back of the 350j is hogging much needed space! Will this design free up any room or will it take up the same if not more space than just the SX board pressed to the side of a 1590G box?
Next
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.