![\"3d](\"https:\/\/www.shapeways.com\/blog\/wp-content\/uploads\/2016\/05\/wedding_vasesfull.jpg\")
<\/a><\/p>\n<\/p>\n
One of the key things I kept in mind while designing the vase was exceeding the minimal guidelines for porcelain by a healthy margin to ensure production went smoothly. While in certain situations you can get by with 3.0mm walls, having walls that are >4.0mm is a much safer bet in addition to making sure any sharp edges are smoothed out. Otherwise, you risk challenges with glazing.<\/p>\n
To create the square vase, I started off with a square base in OnShape.<\/p>\n
Next, I extruded it into a box.<\/p>\n I used the shell tool<\/a> to make it hollow.<\/p>\n I created a new sketch off the face of the top for the \u201ccup\u201d.<\/p>\n Then I extruded again.<\/p>\n Next, I created the neck of the vase.<\/p>\n Then a thicker opening.<\/p>\n To wrap up the main body of the vase I realized I needed some more material on the bottom so I made a foot.<\/p>\n <\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n