NYC College of Technology Continuing Ed 3D Design and Fabrication Course

Our friends across the East river at NYCCT are offering a weekly, 2 month-long introduction to 3D design and printing. If you’re NYC-local and looking to jump start your 3D skills then this course is a great place to start. And if access to instructors and a very reasonable price tag aren’t enough to pique your interest then scope out the machines you’ll get to use here!


Fabrication and 3D Printing begins Tuesday, October 1 and meets every Tuesday until November 26 from 6-9pm.

Register and find more information at ?City Tech Continuing Education

Pin It

One comment

  1. Daryl

    Greetings! Very helpful advice in this particular
    post! It’s the little changes that make the largest changes.
    Thanks a lot for sharing!

Comments are closed.