Products and Design

Learn Foundations of 3D Printing and Introduction to 3D Modeling

Learn the foundations of 3D Printing with an introduction to 3D Modeling with design for 3D printing expert Aaron Trocola.

This class has evolved greatly over the past year and a half. This is an extended version that is essentially two classes: Foundations of 3D Printing, and Introduction to 3D Modeling. The goal of the class is to give a complete primer on printing processes and software, then show how you can apply that knowledge to create your own designs and manufacture them at home or from a service bureau like Shapeways. You will also learn about selling items from your Shapeways shop, custom object co-creation, and the logistics of re-selling printed items through other venues like Etsy and Ebay. 

About me
Shapeways Designer Evangelist
You may also like
3D Printing Industry
Printing the Impossible: Evolution of a Fidget Cube
March 24, 2017
3D Printing Industry
RC Customization Series: The Story so Far
March 10, 2017
Products and Design, Shapeways
3 Ways to Make Your Prints Cheaper
March 1, 2017