This ring has eight ternary crosses dirtributed aroud it's perimeter. As they go around these crosses make one full turn around themselves.

I suggest ordering it in Strong White and Felxible and painting it with nail varnish in a metallic color. This will give it a nice look (see picture).

This was my first object designed in openSCAD.

Pair of mirrored earrings.
Also usable as keychain pendants.
pendant-hole: 2.5mm diameter;
square bars: 3mm width;
designed with OpenSCAD

Very sturdy!

This is a plate with the Haskell sign designed to be worn on the body.

If you don't know the programming language Haskell you can take a look here:
http://www.haskell.org/

It's slightly arced shape makes it optimal as the mainpiece of a headband or a wristband.

It's size is roughly 38x18mm.

The slits are 3mm in wide so that a leather strap can be feed through.
There is also a version with holes instead of slits aviable in my shop.

This is a four hole English pendant style ocarina.

It's tuned in G6 major.
The range is a full octave from G6 to G7.
A Fingering table is included in the images above.
The highest notes are pretty loud.
The lowest are modest; blow in very gently for them!
Keep it dry and don't enclose it airtight!

Only the White Strong & Flexible material was tested yet.
This material works really fine.
Its paintable too.

This is the Broad Thorn Pendant.
(The ten necessary gemstones are not included.
You can get them for example from this unaffiliated shop: nahoppla-shop.)

It has two grommets, one on each end.
So depending on your taste you can wear it upright or sideways.
With 3.9cm length it is quite big and eye catching.

On each of the two twisted sides five 5mm diameter gemstones goes in.

You can even make it multicolored if you'd like,
but single colored designs are definitely more elegant.

Thorns are always assoziated with roses and they have simply to be red
so I've choosen red gemstones for the one depicted above.
It's wonderfully sparkling in bright sunlight.

length ............ 39 mm
approx. diameter .. 16 mm
grommet diamter ... ~4 mm
gem diameter ......  5 mm (not included)

It was only test-printed in unpolished silver. Note that especially the steel versions could have surface roughness that might prefent the gemstones from fitting in properly. Alumide Is very brittle and probably won't be polishable. If you really want to try it give me a note.

20.0mm inner diameter

To get it nicely colored like in the picture or with your favourite colors
you need low melt enamel from a different source. Just google for it.
You can also mix finegrained glowing powder into transparent enamel, for a cool party ring.