This is a set of weapons designed to be used with Dark of the Moon voyager Sentinel Prime figure! Each set includes a pair of swords, a hand blaster and a shield. The swords and blaster can be stored at the back of the shield, which in turn can be stored at the back of the figure or on top of its alt mode!
All the weapons and shield are held by 5mm pegs, so they are compatible with many other figures.
Version 1.5 Edit: Tightened hand peg, similar to original version.
An enlarged version of the "Feuer Frei" scatter blaster, now lengthened to 13 cm to better fit leader class figures. The handle is still a 5mm compatible peg. There are still 2 auxiliary pegs on the side for storage, as well as areas where 3mm c-clips can attach to.
Edit: Thickened front spikes for greater endurance and strength.
A vicious, spiky hand cannon to arm your alien robotic ground troops with! Made to be as accurate to the movie footage as possible, this design contains hoses, armour plates and other features that cannot be easily replicated with conventional molding techniques.
Printing in Strong Flexible is recommended due to the amount of fine, fragile details.
A pair of claw weapons for the HFTD Tomahawk figure! This design is inspired by the appearance of the Wrecker Whirl in the IDW comics, and are meant to emulate his 4 fingered claw design.
Each finger-claw has 2 ball joints and are mounted on a wrist section which can rotate 360d as well.
Because of the fist-sheath that is supposed to hide the original hands of the figure, these claws are not suitable for all figures. As a rough guideline, the width of the figure's forearm should be equal to or narrower than 12mm. Also, the figure should be able to hold a 5mm peg handle.
Edit: I've added spare finger pieces in case any of your fingerjoints break during assembly. This happens when you are printing in Frosted Ultra Detail. A pair of posable hands for the Masterpiece Seeker figure! This is compatible with MP-3 Starscream and all his subsequent repaints. Each hand has a wrist ball joint, thumb ball joints, and 4 individual posable fingers!
This model has been tested successfully with White Strong Flexible and Frosted Ultra Detail. FUD fingers have a 25% chance of breaking so please be careful during assembly.
Edit: Added spare fingers. Just in case! A variant of the hands done for the Masterpiece Seeker figure, but this version has its wrist joint replaced with a ridged peg. The wrist peg is 5mm in diameter and peg section is 7mm long.