This is the bottom part of the OpenPilot CopterControl case. You also need the top part (Case upper v1) and (optionally) the base (Case base 1 v1)....

This is the top part of the OpenPilot CopterControl case. You also need the bottom part and (optionally) the base. More info here: http://wiki.ope...

Part of a wire leg for a multirotor. Each leg needs two hinges. It is held to 1/2" (13mm) square arm with two zip ties. The hinge either holds the ...

One cross arm and two hinges and 3/32 wire make a single multirotor leg. Inspired by legs on Aerovironment Qube.

60 halve tube clamps for 12mm tube. 60 halbe rohr schellen fuer 12mm rohr.

Quadcopter Motor Mount. Specifications: - for 12 mm TREX 450 tail booms - 8x40mm motor mount - mounts motors with base 30mm +/- 3mm - holes adde...

This is a lightweight leg I designed for my hexcopter. Using these legs gives about 6.5 cm of ground clearance under the hexcopter for payload. T...

MookaFrame3D: internal upper plate

Part to build a KK2.0 board protection on a HK q450 frame, youll need 4 of them. With the part "mittelkreuz" or the part "mittelkreuz zu" it will f...