Are you ready for a bit of magic with light and shadows? (plus 3D printing :) )
This tealight holder was designed to look like an abstract piece of art, with three layers of randomly zigzagging tubes.
However, when a tealight is put inside, it casts shadows on near walls which reads "MAGIC×". (Warning! This model was not yet tested. You will most probably be able to read out the letters from the shadow, because I've run simulations in my 3D software for it, and they were there. But real life may differ a bit)
The letters are made out of the zigzagging tubes around the sphere, and there are additional tubes above and under the letters, to create the "whole" sphere.
It is intended to be used with tealighs of up to 4 centimeters (around 1.57 inches) diameter. (Ideally the flame of it is in the center of the sphere)
The model contains a stand for the tealight, and the sphere which fits onto it.
It was designed to be printed out in porcelain material (currently not available), but it is also available in several metallic materials, and sandstone. Plastic materials are not available for safety reasons.