JP harness kit for Bounty Hunter. Designed to replicate the film used JP harness Completely redesigned so there is no assembly other than adding the support bar & strapping & made some areas stronger. The bar that spans both tubes that the JP hooks onto isn't supplied. This can be an 1/8" thick by 1/2" bar of aluminum or steel. There are 2 spots to run a screw through the tubes that is supported all the way through & can be screwed into a flush mounted nut on the opposite side to be firmly attached. The tubes are hollow with an added reinforcement rib running up the middle all the way to the arch. The lower rings are .250" diameter & accept 2 inch wide strapping. The upper rings are .250" diameter x .1875" thick (oval shaped) and will accept 1.5" wide strapping. The upper rings are attached to the harness with a small ring that can be cut off. This is a light alternative weighing in at 5.5 oz. If there are any questions please feel free to contact me.