SRH-771 to Taranis X9D Antenna Holder

A SRH-771 EzUHF Tx Antenna Holder that clamps onto the Handle of the Taranis X9D thus allowing the Antenna to be positioned at a different angle when used in combination with a JR Module.

Not included in the purchase but necessary is a SMA 200mm RG316 Extension Cable, four M3x6 Screws ( I used Discovery Frame Screws ) and four M3 Nuts.

Preparation & Installation:

1. Separate the 4 Pieces from each other and remove the sprue pieces that held them together.
2. Sandwich the Extension Cable between the two smaller Halves.
3. Insert the assembled Cable into the Main Body until it's flush - The inside of the Main Body has a hexagonal area into which the hexagonal part of the Cable must go preventing it from turning later on.
4. Sandwich the Handle of the Remote between the Main Body and the Front Plate - This may take some force as it will lock all 4 pieces together.
5. Use the Nuts and Screws to tighten everything together - Use moderation when doing so and don't try to close the Gap between the two Large pieces.