Mt. Rainier's 14,417-foot peak is visible for nearly one hundred miles
on a good day, and is an iconic feature of the horizon in Western Washington.
A strato-volcano, Mt. Rainier's present cone is one half-million years old
and covered with glaciers that amount to nearly one cubic mile of ice.
Though it last erupted in 1854. Rainier is still potentially active, and because of its
proximity to the densely-settled Seattle-Tacoma area and the massive amount of
ice that would be melted during an eruption, it poses more risk than any other
volcano in the US.
This model showcases Rainier's summit and steep cone, and because we used
the latest USGS high-resolution data, minor features as little as 100' wide are modeled.
Little Tahoma dominates the Eastern slope, the summit crater is obvious,
and crevasses in the mountain's major glaciers are even visible.
If you can't see Rainier every day, or if you can, but only from one angle,
put this mountain on your desk or coffee table and enjoy it whenever you like.
Model scale is 1:25100
Model covers an area approximately 7.8 by 7.8 miles
Altitudes covered: 4109' to 14417'
There is never any vertical exaggeration in TinyMtn models.
Click here for more sizes.
Click here for other 20" models.
TinyMtn models are most affordable in the "White Strong and Flexible" and "Sandstone" materials. This model is in "White Strong and Flexible." When you receive the model, there may still be Nylon dust on it from the printing process. Use either an airbrush, canned dust blower, or a soft old toothbrush to remove this dust. Do not get the "White Strong and Flexible" material wet, and don't prime it or use any oil-based paints on it. You can safely seal it with Polycrylic or a similar water-based clear spray sealant. Read more about this popular material here.
These models have been optimized for the above materials, and are not offered in other materials for strength or cost reasons. If you need one in another material, please contact us and we'll try to accommodate your request.
(C) 2013 TinyMtn (TM)
Model created using GDAL, NetPBM, Gmsh, Carve, MeshLab, and other custom software
Source of digital elevation data: U.S. Geological Survey
The USGS home page is http://www.usgs.gov/