Copy this code to embed this product on your page:
About this Product
Pitot tube holder designed to fit the DIYdrones, Rangevideo and Eagletree etc pitot tube. It is two parts that is glued together. It is designed some extra tolerances because some pitot tubes are thicker and have glue on them etc.
For installation in EPO foam use a 10mm sharp drill and make an elongated hole. The pitot tube is glued in place. For optimal performance make sure the tube is placed in a free airflow unaffected by the airframes boundary layer.
The picture below show an early version that has later been improved.
It was designed for the RVJET but can be used on most foam models.