CUAV Pixhack PMU Case and Holder
Made by
Print With Shapeways
Choose Your Material
Choose your color and finish
Choose Your Material
$27.61
Choose your color and finish
Have a question about this product?
contact the designerYou must be logged in and verified to contact the designer.
Product Description
A CUAV Pixhack PMU Board Case and Holder.
Provides an overall neater look than a purple PCB Board covered in clear heatshrink and has the added benefit of protecting said PCB and it's components from a hard landing.
Be aware that proper installation requires you to solder an XT60 Plug directly to the PCB in order to get the desired result ( Check this Positioning Guide what to look out for )
Requires one TBS Frame Spacer Screw to hold the two halves of the Case together.
Preparation & Installation:
- Solder an XT60 Plug to the IN Solder Pads of the PMU ( see Guide ) and regular Leads to OUT
- Separate the two Case pieces from each other by breaking the sprues holding them together
- Insert the CUAV Pixhack PMU with the XT60 Plug head first into the larger piece of the Case
- Close the Cover using the smaller piece of the Case
- Use a TBS Frame Screw to hold the two pieces together ( see Picture )
- Slide a TBS Frame Standoff through the partially open hole and install everything onto the TBS Discovery
Details
What's in the box:
PMU
Dimensions:
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
