Click and drag to rotate
30 tine knitting garter bar X 2 - 8mm v3 3d printed 8mm - 30 stitch ( two 15 stitch )

DIGITAL PREVIEW
Not a Photo

8mm - 30 stitch ( two 15 stitch )
30 tine knitting garter bar X 2 - 8mm v3 3d printed 8mm - 30 stitch ( two 15 stitch )
30 tine knitting garter bar X 2 - 8mm v3 3d printed 8mm - 30 stitch ( two 15 stitch )

DIGITAL PREVIEW
Not a Photo

30 tine knitting garter bar X 2 - 8mm v3 3d printed Expand with 1/4" threaded rod
30 tine knitting garter bar X 2 - 8mm v3 3d printed Expand with 1/4" threaded rod

DIGITAL PREVIEW
Not a Photo

30 tine knitting garter bar X 2 - 8mm v3 3d printed Garter Bar
30 tine knitting garter bar X 2 - 8mm v3 3d printed Garter Bar

DIGITAL PREVIEW
Not a Photo

30 tine knitting garter bar X 2 - 8mm v3 3d printed
30 tine knitting garter bar X 2 - 8mm v3 3d printed

DIGITAL PREVIEW
Not a Photo

30 tine knitting garter bar X 2 - 8mm v3

Made by
Print With Shapeways
Choose Your Material
$31.72
Choose your color and finish
QTY

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
This is a 30 needle garter bar made up of two 15 Needle / Tine 8mm Garter Bars: (the one 15 needle version is also available in this store) A garter bar is used on a knitting machine to remove the knitted fabric from the needles, turn it around, and replace the knitted fabric back on the needles. The ability to do this for an entire section of fabric (not just one needle) is necessary for garter stitches, and some lace patterns and cables. It can also be used if you have a need to temporarily remove a project from the machine.  It fits 8mm machines. Purchase the number of sections you need, depending on the number of needles in your typical project. Any number of sections can be used. The sections fit together and should be secured together using a piece of 1/4” threaded rod with nuts and washers on the ends. Threaded rod is inexpensive and can be purchased at a hardware store. The rod should be cut to the length of the assembled garter bars, with enough room to add a nut and washer at each end. Note that this just needs to hold them together for convenience, it doesn’t need to be very tight. The material default for printing this is “White Polished”. Without the “Polished”, the surface of the material is slightly rough.  If you find that your yarn still doesn’t slide easily on and off the garter bar, spray it with several coats of a glossy clear coat spray available at craft and hardware stores.  This will help smooth the surface even more.

 
Details
What's in the box:
30 tine knitting garter bar X 2 - 8mm v3
Dimensions:
12.28 x 5.21 x 1.69 cm
Switch to inches
4.83 x 2.05 x 0.67 inches
Switch to cm
Success Rate:
First To try.
What's this?
Rating:
Mature audiences only.
Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.