Electric Glove Fingers Set - Test

Electric Glove Fingers Set - Test 3d printed Accessories Rings
Electric Glove Fingers Set- an additional option to enhance you prop appearance! --- --- This set is intended to go with the Electric Glove Kit: http://theatomicsoul.storenvy.com/products/1219492-electric-glove-kit --- --- SIZE NOT CONFIRMED. --- --- This was created to fit OVER a pair of Footjoy Wintersof Mens ML Golf Gloves. While wearing the gloves my ring finger measures 0.785in (19.95mm) wide at my knuckle and only a little loose at this size where my ring would rest. Measure at the knuckle to be sure the parts will slide off, and measure WITH your chosen glove ON to ensure they will fit while the glove is being worn. I also adjusted the thumb last, but have not received it yet. Until it is confirmed printing is at your own risk for size. Once received and confirmed this file or document will be updated and adjusted ring sizes will be made available. --- --- Hollowed knuckle: I also modified the design in a small way to help reduce the price; it was not a large reduction, but anything to help save on cost is a good change! As I printed mine before this change I did not get to test the results but it should in no way effect the stability of the parts or design. ---
cm: 10.324 w x 10.048 d x 8.212 h
in: 4.065 w x 3.956 d x 3.233 h


  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.