Buttonhole Ring

Buttonhole Ring 3d printed Jewelry Personalize your own As made: No thread
As made: No thread
Buttonhole Ring 3d printed Jewelry Personalize your own As Made: Without Thread
Buttonhole Ring 3d printed Jewelry Personalize your own As Made: Without Thread
As Made: Without Thread
Buttonhole Ring 3d printed Jewelry Personalize your own As made: No thread
Buttonhole Ring 3d printed Jewelry Personalize your own As made: No thread
As made: No thread
3d Model Viewer
Buttonhole Ring 3d printed Jewelry Personalize your own
Buttonhole Ring 3d printed Jewelry Personalize your own
The button goes through the hole... or does it? Use a needle and thread to give this ring a little something extra. Ring is slightly adjustable. Whole and half sizes only, please.
cm: 2.178 w x 2.958 d x 1.1 h
in: 0.857 w x 1.165 d x 0.433 h

Comments

 
This ring looks like a button and a button hole, but of course it isn't. It's one continuous piece of steel. It i printed with 4 holes that you can put thread through-- just use a scrap of your favorite color. Use a little candle wax to stiffen one end if you don't have the right needle. Tie a not under the button and clip with nail scissors.
April 4, 2010, 5:46 pm
 
  • Stainless Steel

    Bronze-infused stainless steel with visible print lines and rough feel.

    $35.00

Personalize
Favorited by