Stargate SG1 - Ha'Tak [80mm/Hollow/2 Parts]

Stargate SG1 - Ha'Tak [80mm/Hollow/2 Parts] 3d printed SciFi
This is a highly detailed model of the Goa'uld Ha'Tak Mothership from Stargate SG1. This model has been produced due to popular demand and has been broken into two parts to allow ease of painting.
Tags:
SciFi
cm: 8.018 w x 7.696 d x 3.43 h
in: 3.157 w x 3.03 d x 1.35 h

Comments

 
A big thanks to everyone who has bought this model and especially to everyone who is posting their great images of the models here on the website. By way of thank you I would love to run a painting competition if people are interested. Starting today we would like people to upload the best images they have of their Ha'tak and the winner will receive a free model of our Batman Tumbler (Check out the 3D printed Batman - Tumbler Car [80mm & Solid] http://shpws.me/owCZ via @Shapeways)
February 4, 2014, 4:11 am
i finally got around to painting this model (bought it last august). thought i'd share the pics. thank you again for creating such an AWESOME & well detailed piece.
February 4, 2014, 1:44 am
just got mine today in the WSF... couldn't be happier with it... the detail in the WSF adds such an awesome texture to it. THANK YOU for designing such a wonderful piece!!!
August 13, 2013, 10:01 pm
Here a close-up of the pyramid part. I really like the texture of the WSF material here, I guess it will add even more detail to the already amazing looking surface.
February 22, 2013, 9:06 am
I got my print in WSF. I own the 1-part-version already, and this 2-aprt variant will be much, MUCH easier to paint. Great work!
February 22, 2013, 8:55 am
@Tamereth I have received a message from Shapeways. They say that for a polished version they want the parts to be 0.5mm (however this is not mentioned anywhere on their website). The model is built for 0.2mm so I think a polished version would probably push this down to 0.1mm and therefore outside of their limits and thus lose the detail. To make everything 0.5mm would make the detail almost twice as big and I think it would start to look very chunky.
February 21, 2013, 4:11 pm
@Speed Thanks for that. In the meantime i have ordered the 1 part version of the model, will be a bit harder to paint but will look just as good once it's done.
February 21, 2013, 2:04 pm
@Tamereth I have asked Shapeways to explain why as we have built to the tolerances of 0.2mm detail and they have asked for 0.5mm which is not required for this material.
February 20, 2013, 12:59 pm
Was unable to print in white strong and flexible polished material.
February 20, 2013, 12:20 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $27.67

Favorited by