Attack from Mars: Alien Armature

Design by wedsall

(0)

0 out of 5
*
*
*
*
*

(0) Comments

note: although my 3d file included the threads, this piece does not come with accurate threads. You must tap this with an 8-32 tap. For me, it tapped very well and takes an 8-32 screw well.

Shown tapped 8-32 accepting a screw.

Fully inserted screw into tapped hole.

Shown with another model on my store - one of the martian brackets. The bracket fits nicely. NOTE: this bracket is sold separately.

Fully mounted with bracket and screw.

This part replaces the Alien armature on an Attack from Mars pinball machine. You need to attach this to a solenoid plunger. It's up to you to determine the proper plunger - personally I've used the same ones as the kicker in an AFM and they've worked well. This part just happens to be unavailable while the kicker armatures are available.

NOTE: This part does NOT COME TAPPED! The model file includes threads but they aren't printing properly. You must tap this with an 8-32 tap. It tapped well for me.

Version 1.1: Shapeways was declining the parts because near the top the wall was less than 7mm thick. 2 changes were made
1. Removed the threading since it doesn't print well anyways, changed the hole to a #29 diameter.
2. Added a little thickness to the screw hole just to get past the bracket mount, where the part was considered too thin.

cm: 0.766 w x 0.768 d x 12.542 h

in: 0.302 w x 0.302 d x 4.938 h