Pictured is the entire assembly on a working machine. The only part for sale is the black coil cover on top of the saucer weldment.
Pictured is the entire assembly on a working machine. The only part for sale is the black coil cover on top of the saucer weldment.
birds eye view
This new style coil cover has one small opening for cables
side view. note the washer under the front screw holes. This is a picture of the first prototype, and the plunger hole was about 1/16 too low - these washers were used to solve the issue. This issue is resolved in version 1.1
This model has been re-designed as an improvement to the original. Notice the small wire exit hole and redesigned angles on the front side.
v1.1: Solenoid plunger hole has been moved up 1/16 in for plunger clearance.
This model replaces the saucer coil cover on an Attack from Mars pinball machine. In the featured pictures, this model has been printed in 'Black Strong & Flexible' material.
This is _not_ an exact replacement for the original part. This part has been modified slightly. Some modifications include:
* More form-fitting angles on the plunger side
* Completely enclosed lower-front side with one small opening for saucer wiring
* The 'dip' on the back side of the coil cover has been made completely square
* The original part had a hole for which to mount a post and rubber. The hole is not included in this part but you could easily drill and mount one if needed.
This part has been purchased by myself and tested in a working machine as seen in the pictures above.
Use at your own risk. Thanks for looking!
This model replaces the saucer coil cover on an Attack from Mars pinball machine. In the featured pictures, this model has been printed in 'Black Strong & Flexible' material.
This is _not_ an exact replacement for the original part. This part has been modified slightly. Some modifications include:
* More form-fitting angles on the plunger side
* Completely enclosed lower-front side with one small opening for saucer wiring
* The 'dip' on the back side of the coil cover has been made completely square
* The original part had a hole for which to mount a post and rubber. The hole is not included in this part but you could easily drill and mount one if needed.
This part has been purchased by myself and tested in a working machine as seen in the pictures above.
Use at your own risk. Thanks for looking!
cm:
15.398 w x
6.35 d x
5.398 h
in:
6.062 w x
2.5 d x
2.125 h
Select Country
$ United States
Material Options
-
Black Strong & Flexible
$70.95
-
White Strong & Flexible
$57.86 -
Black Strong & Flexible
$70.95 -
Frosted Ultra Detail
$196.25 -
Frosted Detail
$137.55 -
White Detail
$167.07 -
Black Detail
$167.07 -
Transparent Detail
$167.07
Comments