- For Your Home
Mt. Rainier's 14,417-foot peak is visible for nearly one hundred miles on a good day, and is an iconic feature of the horizon in Western Washington. A strato-volcano, Mt. Rainier's present cone is one half-million years old and covered with glaciers that amount to nearly one cubic mile of ice. Though it last erupted in 1854. Rainier is still potentially active, and because of its proximity to the densely-settled Seattle-Tacoma area and the massive amount of ice that would be melted during an eruption, it poses more risk than any other volcano in the US.
This model showcases Rainier's summit and steep cone, and because we used the latest USGS high-resolution data, minor features as little as 100' wide are modeled. Little Tahoma dominates the Eastern slope, the summit crater is obvious, and crevasses in the mountain's major glaciers are even visible. If you can't see Rainier every day, or if you can, but only from one angle, put this mountain on your desk or coffee table and enjoy it whenever you like.
Model scale is 1:125400
Model covers an area approximately 7.8 by 7.8 miles
Altitudes covered: 4109' to 14417'
There is never any vertical exaggeration in TinyMtn models.
TinyMtn models look best in the default "White Strong and Flexible" material, which is also the least expensive material. When you receive the model, there may still be Nylon dust on it from the printing process. Use either an airbrush, canned dust blower, or a soft old toothbrush to remove this dust. Do not get the "White Strong and Flexible" material wet, and don't prime it or use any oil-based paints on it. You can safely seal it with Polycrylic or a similar water-based clear spray sealant. Read more about this popular material here.
The "Frosted Detail" material will show more detail, but is semi-transparent and has an uneven surface texture when unpainted (due to the orientation of the model when Shapeways prints it). It may show up feeling a little greasy and with small crystals in crevasses. Clean those off by soaking the model in warm (but not hot) soapy water and brushing with an old toothbrush. To get the surface to an even matte finish, spray with a few light coats of sandable primer (white automotive primer works), and then do a baking soda grit-blast.
These models have been optimized for the above materials, and are not offered in other materials for strength or cost reasons. If you need one in another material, please contact us and we'll try to accommodate your request.
(C) 2013 TinyMtn (TM)
Model created using GDAL, NetPBM, Gmsh, Carve, MeshLab, and other custom software
Source of digital elevation data: U.S. Geological Survey
The USGS home page is http://www.usgs.gov/
White Strong & Flexible
White Strong & Flexible
White Strong & Flexible Polished
Black Strong & Flexible
Coral Red Strong & Flexible Polished
Hot Pink Strong & Flexible Polished
Royal Blue Strong & Flexible Polished
Violet Purple Strong & Flexible Polished
Frosted Ultra Detail
Once a month we hold our live video chat with the Shapeways community.
That moment is happening now.
Join us at shapeways.com/community/live