Arduino Case

Description
 
5.7 w x 0.9 d x 5.6 h in cm |

This ia a modular case for the Arduino Microcontroller. It has been designed to fit 6 across in a 1U Rack with a little room to spare. M3 Screws are suggested and not included. The holes have not been drilled or tapped, so you can use #4-40 screws as well.

 Permalink
 Report abuse
 2
 
Comments  2

Log in if you would like to leave a comment
Sorry for the delay in getting back to you. Apparently either Shapeways failed to email or I failed to read the notification.

If you are interested I can try changing the structure to see if that can decrease the cost, but at the moment I am mostly working on trying to adapt the case for injection molding. Unfortunately I don't think the newer designs will be rack mountable to make sure they can fit one shield.
Fri Mar 5 23:35:41 2010 by IHeartEngineering
What sort of pricing would you end up with if the housing changed from a sealed box to more of a structural-honeycomb-only?

That is: If you're rackmounting, you aren't so worried about fingers, soda, etc. Just holding it in place and preventing unexpected shorts.
Wed Feb 24 22:33:41 2010 by Alan S. Blue
  $
Select material
 
 
'; sfHover = function() { var sfEls = document.getElementById("nav").getElementsByTagName("LI"); for (var i=0; i