Arduino Case

Design by IHeartEngineering

(7)

3.57 out of 5
*
*
*
*
*

(2) Comments

Contact Designer

Description

3D Render

Main View

Description

Assembled

This ia a modular case for the Arduino Microcontroller. It has been designed to fit 6 across in a 1U Rack with a little room to spare. M3 Screws are suggested and not included. The holes have not been drilled or tapped, so you can use #4-40 screws as well.

cm: 14.4 w x 2.2 d x 14.2 h

in: 5.669 w x 0.866 d x 5.591 h

Comments

You must login to leave a comment

IHeartEngineering says:

Flag as inappropriate

Sorry for the delay in getting back to you. Apparently either Shapeways failed to email or I failed to read the notification. If you are interested I can try changing the structure to see if that can decrease the cost, but at the moment I am mostly working on trying to adapt the case for injection molding. Unfortunately I don't think the newer designs will be rack mountable to make sure they can fit one shield.

March 5, 2010, 11:35 pm

AlanS.Blue says:

Flag as inappropriate

What sort of pricing would you end up with if the housing changed from a sealed box to more of a structural-honeycomb-only? That is: If you're rackmounting, you aren't so worried about fingers, soda, etc. Just holding it in place and preventing unexpected shorts.

February 24, 2010, 10:33 pm