Arduino Case

Arduino Case 3d printed Mechanical parts Miniatures Description
Description
  • Sandstone

    Delicate and grainy, with a coarse finish and sand-like color.

    $43.06

This ia a modular case for the Arduino Microcontroller. It has been designed to fit 6 across in a 1U Rack with a little room to spare. M3 Screws are suggested and not included. The holes have not been drilled or tapped, so you can use #4-40 screws as well.

Dimensions

IN: 5.669 w x 5.669 d x 5.669 h
CM: 14.4 w x 2.2 d x 14.2 h

Comments

 
Sorry for the delay in getting back to you. Apparently either Shapeways failed to email or I failed to read the notification. If you are interested I can try changing the structure to see if that can decrease the cost, but at the moment I am mostly working on trying to adapt the case for injection molding. Unfortunately I don't think the newer designs will be rack mountable to make sure they can fit one shield.
March 5, 2010, 11:35 pm
What sort of pricing would you end up with if the housing changed from a sealed box to more of a structural-honeycomb-only? That is: If you're rackmounting, you aren't so worried about fingers, soda, etc. Just holding it in place and preventing unexpected shorts.
February 24, 2010, 10:33 pm