YAITO: Yet Another Inception Totem (Top)

YAITO: Yet Another Inception Totem (Top) 3d printed Memorabilia Desk Toys

The spinning top from the movie Inception, modeled by comparing scenes from the movie.

It is an inch tall (2.5 cm) and about the same width; it may seem a bit small at first but after playing with it for a while I find it very comfortable. Mine was printed in stainless steel and it will spin for over a minute; the puckered texture gives it a nice feel and somehow the outer curves are very smooth.

One word of advice: tempting as it may be, try not to spin it on a nice wooden surface, it may scratch it and in some cases dig itself a comfortable dent to rest on (see picture). Then again, sometimes you want an excuse to buy a new desk :)


cm: 2.234 w x 2.492 d x 2.234 h
in: 0.88 w x 0.981 d x 0.88 h

Comments

 
Good to hear! Thanks for sharing!
March 6, 2014, 8:34 pm
It spins very well and for a long time.
March 6, 2014, 12:50 am
Did you like it? Please post a picture of your YAITO!
January 8, 2014, 4:32 pm
 
  • Alumide

    Grey nylon plastic with a subtle metallic sparkle.

    $5.38

Favorited by