This is the basic frame of the Imploder Sphere from the movie "The Arrival"
The way you finish this model is by using sculpy clay to build up the texture. After you make the clay texture, you put it in the
oven for 15 min and the sculpy will harden. You can then paint it and display it.
I have added handles inside the model so that you can slide the wings internally with a small RC model Servo.
Should be a fun project for anyone who liked the arrival.
There are 4 parts to this model.
here are the links to all 4 parts.
Wing handles. You will need to glue or fasten them on with screws.
Slide out wings. The wings have holes where you will insert a reflective foil as seen in the prop photo above. You can also cut
out a mirror if you have a glass cutter.
This is the top body. As you can see there are slots for the wings to slide.
8.038 w x
8.594 d x
3.165 w x
3.383 d x