1:300 turrets (x 16) for OT-64

1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles The H&R model, before the turret is added.
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles The H&R model, before the turret is added.
The H&R model, before the turret is added.
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles The H&R model, after the turret has been added (this one done in WSF).
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles The H&R model, after the turret has been added (this one done in WSF).
The H&R model, after the turret has been added (this one done in WSF).
3d Model Viewer
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles The finished article.
1:300 turrets (x 16) for OT-64 3d printed Miniatures Vehicles The finished article.
The finished article.
Set of 16 turrets for converting the Heroics & Ros 1:300th scale OT-64 model into an OT-64A (or SKOT-2A if in Polish service). A 0.3 mm diameter wire (not provided!) needs to be inserted into the hole in each turret face to model the 14.5 mm HMG. The base of the turret has a lug so it slots into the gap between the hatches on the top deck of the H&R OT-64 model. I simply put a tiny piece of bluetac to fix the turret onto the model, it does the job fine. Note that the moulding sprue is attached to the top of the turret, so you will need to give the turret a quick file down after you have cut off the sprue. A chore, to be sure, but it's the only place it can be attached... The photos show before and after shots of a print-out using the cheapest WSF plastic.
cm: 5.552 w x 0.488 d x 1.04 h
in: 2.186 w x 0.192 d x 0.409 h

Comments

 
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $2.55

Favorited by